![]() The report provides information including: The Autorouter conducts its own pre-routing analysis and presents the results as a report in the dialog. UseĪfter launching the command, the Situs Routing Strategies dialog will open. This command is accessed from the PCB Editor by choosing the Route » Auto Route » All command from the main menus. The greatest strengths of this approach are that the map is shape independent (the obstacles and routing paths can be any shape) and the space can be traversed at any angle - the routing algorithms are not restricted to purely vertical or horizontal paths, as with a rectilinear expansion routers.įor a high-level look at this approach to auto-routing, see Topological Autorouting. This triangulated map is then used by the routing algorithms to "weave" between the obstacle pairs from the start route point to the end route point. It does this by triangulating the space between adjacent obstacles. ![]() Rather than using workspace coordinate information as a frame of reference (dividing it into a grid), a topological autorouter builds a map using only the relative positions of the obstacles in the space, without reference to their coordinates. A topological autorouter uses a different method of mapping the routing space - one that is not geometrically constrained. This command is used to route the entire board using the Situs Autorouter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |